A motorcycle backpack is a pack designed to be worn while riding: slim and close to the body so it does not catch the wind, held by a sternum strap and ideally a waist strap so it cannot slide or lift, shaped to sit flat on a leaning back, and waterproof, because a rider is exposed to rain and road spray for the whole journey. Most riders need 15 to 25 litres for commuting and day rides. For heavier loads, a tail bag or a strap-on bag that comes off as a backpack takes the weight off the rider. This guide explains what changes when a backpack goes on a motorcycle, what to look for, and the waterproof riding packs we manufacture.
Most riders start with whatever backpack they already own, and most find out within a week why it does not work. At speed the wind gets under the top of the pack and pulls it backwards. Under braking it slides forward into the helmet. In the rain, water is driven through the zipper and the seams. None of this is a problem walking down the street, which is why a riding backpack is built differently.
The harness comes first. A backpack without a sternum strap, and ideally a waist strap, will move around under braking and cornering. The sternum strap should sit high on the chest and be easy to fasten with gloves on; the waist strap, where fitted, should sit clear of the tank so it does not scratch the paint when you lean. On sports bikes, where the rider is tucked forward, an ordinary pack tends to slide up towards the helmet, which is why some riding packs use a four-point chest harness instead of two vertical straps.
Shape is second. A slim, contoured pack that sits close to the back has less drag and less lift than a tall, deep one. Compression straps that cinch the load down help a half-full pack keep a low profile. Avoid anything that rises above the shoulders, because it will push against the back of the helmet in a tuck and catch the air at the top.
Weather is third. On a motorcycle the rain is driven at the pack at road speed and the rear tyre throws spray at the base, which is far harder on seams and zippers than walking in a shower. A pack with high-frequency welded seams has no stitching holes in its shell, and a waterproof or airtight zipper closes the last gap. For riders who commute all year, that is the difference between a dry laptop and a dead one. What the ratings mean is explained in our guide to waterproof ratings for bags.
Gloves change everything. Zipper pulls, buckles and strap adjusters need to be big enough to use in winter gloves. Our SL-E698 has a dual-slider airtight zipper with a large D-ring pull for this reason, and it opens from either end so the most-used items are reachable without opening the whole pack.
Visibility matters. Reflective panels or webbing on the back of the pack face the traffic behind you, at night and in rain. A sleeve that takes a laptop or a back protector insert adds versatility, though a pack is no substitute for a proper riding jacket with armour. Off-road riders often add a hydration bladder, and a slim, tough pack like our 15 litre SL-E127 suits dirt bike and trail riding.
And think about pressure. A fully airtight pack traps air when it is closed, and it can balloon at altitude or when it warms up. A pressure-relief valve, as on our SL-E1313, releases trapped air without letting water in.
On long rides and with heavy loads. Weight on the rider's back adds fatigue to the shoulders and neck over hours, and moves the centre of gravity higher. Many riders prefer tail bags or saddlebags for long trips to keep the weight off their back. A good compromise is a bag that rides strapped to the seat and becomes a backpack when you arrive: our 55 litre SL-E984 straps on with four quick-release straps and carries on a padded harness off the bike. Our articles on the motorcycle duffel bag and the best waterproof motorcycle bag cover these options.
| Image | Model | Capacity | Dimensions (H × W × D) | Weight | Construction | Use |
|---|---|---|---|---|---|---|
|
SL-E698 | 25 L |
54 × 27.5 × 16.5 cm 21.3 × 10.8 × 6.5 in |
1.05 kg | Welded TPU, dual-slider airtight zipper with glove-friendly D-ring pull, sternum strap, IPX7 | Commuting and touring; opens from either end with gloves on |
|
SL-E641 | 24 L |
54 × 27.5 × 16.5 cm 21.3 × 10.8 × 6.5 in |
1.0 kg | Welded TPU, single-slider airtight zipper, smooth low-drag front, sternum strap, IPX7 | Clean, low-profile commuter pack |
|
SL-E119 | 20 L |
47 × 31.5 × 14.5 cm 18.5 × 12.4 × 5.7 in |
0.86 kg | Welded TPU, airtight zipper, padded laptop compartment, side compression straps, IPX8 to 20 m | Laptop commuting through any weather |
|
SL-E1313 | 22 L |
50 × 30.5 × 14.5 cm 19.7 × 12 × 5.7 in |
0.85 kg | Welded 500D TPU, waterproof zipper, pressure-relief valve, 16 in laptop, IPX6 | Office commuter; valve stops the pack ballooning |
|
SL-E127 | 15 L |
44 × 28 × 12 cm 17.3 × 11 × 4.7 in |
0.65 kg | Welded 900D TPU, waterproof zippers, airflow back panel, sternum strap, reflective webbing, IPX6 | Dirt bike and trail riding; slim and tough |
|
SL-E984 | 55 L |
26 × 57 × 32 cm 10.2 × 22.4 × 12.6 in |
1.27 kg | Welded TPU, airtight zipper, four quick-release mounting straps, padded harness, IPX7 | Rides strapped to the bike, carried as a backpack off it |
The SL-E984 is measured lying flat as a bag; on the back its 57 cm length runs across the shoulders. The full motorcycle range is in our waterproof motorcycle bag category.
For motorcycle brands and dealers, the details that set a riding pack apart are a high, glove-friendly sternum strap, an optional waist strap that clears the tank, a slim contoured shell, reflective trims, a laptop or back protector sleeve, a hydration port for off-road models and a waterproof construction that survives a day of motorway rain. We build these packs with welded shells and waterproof or airtight zippers, and can add a hook-and-loop panel for club or dealer patches, custom colours and branded hardware. Note that the SL-E984 carries a registered design patent, so brands wanting a similar three-way bag are developed with an original shape. The MOQ is 300 pieces per design (500 on the SL-E119 and SL-E127), samples take 7 to 15 days and bulk production 30 to 45 days, quoted FOB Guangdong with Vietnam origin available. Sealock has over 20 years of experience making waterproof bags. For the manufacturing side, see our article on wholesale motorcycle waterproof bags.
Yes, with a pack designed for riding and secured with the chest and waist straps so it cannot shift. Keep it light, and use a tail bag or panniers for heavy loads.
Wind gets under the top of the pack and lifts it. A slimmer pack, a tight sternum strap and a waist strap stop it.
15 to 25 litres for commuting and day rides. Larger packs get heavy and tall; carry big loads on the bike instead.
Many are only water-resistant. For riding in rain, look for welded seams and a waterproof or airtight zipper, rated IPX6 or above.
Some have a helmet holder or are large enough inside. Most commuter packs of 20 to 25 litres are not.
Only slightly. Some packs take a back protector insert, but your jacket and armour remain the main protection.
Tell us the capacity, harness, closure, laptop size, colours and quantity you need, and we will reply within 24 hours with suitable base models, an FOB price and a sample timeline. Contact Sealock, or email info@sealock.com.hk.